EasyManua.ls Logo

Minebea CSD-912B - 2-Wires Method Serial Interface (Serial Interface) Wiring

Default Icon
366 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9.2.2-wires method serial interface (serial interface)
215
External equipment
9
$XWRPDWLFSULQWELW)81ELW
The automatic print bit can be used as a trigger on receiving-side equipment of the 2-wires
method serial interface (serial interface). It is normally0.
'LVSOD\ELW67ELWELW
%LW6HWZKHQ&6'%VGLVSOD\LVJURVVZHLJKW
%LW6HWZKHQ&6'%VGLVSOD\LVQHWZHLJKW
POINT
- Serial data is output only during weighing operation.
- Setting the maximum number of display digits to 6 stops the data output of the
2-wires method serial interface (serial interface). To use the 2-wires method serial
interface (serial interface), set the maximum number of display digits to a value of
5 or less.
9.2.3.
2-wires method serial interface (serial interface) wiring
The 2-wires method serial interface (serial interface) is wired to +, -, and F.G. of the RS-485
interface terminal block, which is located at the back of CSD-912B.
POINT
- The end of each cable should be stripped 7 mm.
- The terminal block terminal screw tightening torque is0.6 N·m.
7KHZLULQJFDEOHVVKRXOGEH$:*WR$:*
:KHUHSRVVLEOHXVHFDEOHVZLWKFRUHVKLHOGHGFDEOHZLUHV:LUHWKHVKLHOGWR
WKH)*WHUPLQDO:KHQFRUHVKLHOGHGFDEOHZLUHVDUHQRWXVHGWZLVWFDEOHV
:KHQFRUHVKLHOGHGFDEOHZLUHVDUHXVHGWKHFDEOHOHQJWKVKRXOGEHPRU
VKRUWHU:KHQQRWXVHGWKHFDEOHOHQJWKVKRXOGEHPRUVKRUWHU
- External control input and the common terminal of the 2-wires method serial
interface circuit are shared.
- To conform CSD-912B to the CE mark applicable standards and the JIS
standards, wire a shielded cable wire to each F.G. terminal of the RS-485
interface terminal block and the 2-wires method serial interface terminal block.
- The 2-wires method serial interface supporting equipment include printer M252B
(by UNIPULSE Corporation), etc.
- Up to three pieces of 2-wires method serial interface supporting equipment can
EHZLUHGLQSDUDOOHOPD[LPXPRXWSXWFXUUHQWDSSUR[P$'&
2-wires method serial interface terminal block
$SSOLFDEOHSOXJ;:%%+E\20521
CSD-912B
Internal equiva
-
lent circuit
2-wires method
serial interface
supporting
equipment

Table of Contents

Related product manuals