Minebea CSD-912B - Decimal Point Position Setting

181
Various settings
7
7.1.Settings related to the screen display
3) Check the setting that you set
1. Check the display rate.
The setting is completed if the item set by the step
DERYHDSSHDUVXQGHU>',635()5(6+5$7(@
7.1.2. Decimal point position setting
A decimal point position of the load value display is set.
1) Display the decimal point position setting screen
1. Tap [CALIBRATION] on [MENU 1/2].
>&$/,%5$7,21@ZLOOEHGLVSOD\HG
2. Tap [DECIMAL POINT].
The decimal point position setting screen will be
displayed.
2) Set a decimal point position
1. Select a decimal point position.
Selections: 0, 0.0, 0.00, 0.000, 0.000 0
Initial value: 0
2. Tap [OK].
The decimal point position will be set, and
>&$/,%5$7,21@ZLOOEHGLVSOD\HG
3) Check the setting that you set
1. Check the decimal point position.
The setting is completed if the item set by the step
DERYHDSSHDUVXQGHU>'(&,0$/32,17@