Minebea CSD-912B - Settings before Measurement

102
Measurement
5
0HDVXUHPHQWLQVXSSOHPHQWDU\ÀRZGLVFKDUJHPRGH
 0HDVXUHPHQWLQVXSSOHPHQWDU\ÀRZ
discharge mode
:KHQWKHYROXPHRIWKHIHGGLVFKDUJHGPHDVXUHGREMHFWLVLQVXI¿FLHQWWKHGH¿FLHQF\LV
automatically supplied. If [CONTROL MODE] is [BATCH MODE], small amount is fed to the
ZHLJKLQJKRSSHU,I>&21752/02'(@LV>',6&+$5*(02'(@VPDOODPRXQWLV
GLVFKDUJHGIURPWKHZHLJKLQJKRSSHU
%HIRUHPDNLQJDPHDVXUHPHQWHQWHUQHFHVVDU\VHWWLQJVLQDGYDQFHIRUPHDVXUHPHQWLQ
VXSSOHPHQWDU\ÀRZGLVFKDUJHPRGH
5.5.1. Settings before measurement
7RPDNHDPHDVXUHPHQWLQVXSSOHPHQWDU\ÀRZGLVFKDUJHPRGHDIWHUHQWHULQJWKHQRUPDOVHWWLQJV
RI>6(48(17,$/02'(@ĺ6HWWLQJVEHIRUHPHDVXUHPHQWVHWWKHIROORZLQJLWHPV
- [MAXTIME OF COMPENSATION]
- [COMPARISON FLOW EVAL]
- [SUPPLEMENTARY FLOW TIME] and [JUDGE. AFTER S-FLOW WAIT] of [BRAND
CODE].
Set [MAXTIME OF COMPENSATION] and [COMPARISON FLOW EVAL] on Sequence control
VFUHHQ7DS>6(48(1&(&21752/@RQ>0(18@WRGLVSOD\6HTXHQFHFRQWUROVFUHHQ
6HW>6833/(0(17$5<)/2:7,0(@DQGWKHZDLWLQJWLPHDIWHUVXSSOHPHQWDU\ÀRZRI
>%5$1'&2'(@RQ>%5$1'&2'(@VFUHHQ7DS>%5$1'&2'(@RQ>0(18@WR
display [BRAND CODE] screen.
Refer to "5.2.3. Brand settings" for more information about [BRAND CODE].
[MAXTIME OF
COMPENSATION]
[COMPARISON
FLOW EVAL]
[SUPPLEMENTARY
FLOW TIME]
[JUDGE. AFTER
S-FLOW WAIT]