Minebea CSD-912B - Use of Automatic Free Fall Compensation

93
Measurement
5
5.4. Measurement in sequential mode
5.4.4. Use of automatic free fall compensation
>))//@WKDWZLOORFFXUDWWKHQH[WPHDVXUHPHQWLVDXWRPDWLFDOO\FDOFXODWHGXVLQJWKHDFWXDO
>))//@WKDWKDYHRFFXUUHGLQWKHSDVWPHDVXUHPHQWVWRFRUUHFWZHLJKLQJYDOXHV
To use automatic free fall compensation, after entering the normal settings of [SEQUENTIAL
02'(@ĺ6HWWLQJVEHIRUHPHDVXUHPHQWVHWWKHIROORZLQJLWHPV
- [A. F. F. COMPENSATION]
- Saving automatic free fall compensation values
- [A. F. F. COMPENSATION] of [BRAND CODE]
POINT
- Refer to "5.2.3. Brand settings" for more information about [BRAND CODE].
(1) [A. F. F. COMPENSATION] settings
To use automatic free fall compensation, enable [A. F. F. COMPENSATION].
1) Display the screen to set [A. F. F. COMPENSATION]
1. Tap [SEQUENCE CONTROL] on [MENU 1/2].
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
2. Tap [A. F. F. COMPENSATION] on [SEQUENCE
CONTROL 2/3].
7KHVFUHHQWRVHW>$))&203(16$7,21@ZLOOEH
displayed.
2) Enable [A. F. F. COMPENSATION]
1. Tap [VALID].
Default: [INHIBIT]
2. Tap [OK].
[A. F. F. COMPENSATION] has been set to [VALID],
DQG>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
POINT
6HWWLQJ>,1+,%,7@PDNHVDXWRPDWLFIUHH
fall compensation unavailable.