Minebea CSD-912B - Conformed Standards

Safety precautions
v
,QVWDOO&6'%EDVHGRQWKHVSHFL¿HGGLPHQVLRQVDQGVHFXUHHQRXJKVSDFH
surrounding it.
Damaging the display may cause leakage of liquid crystal. Take care not to get it
in your eyes or mouth. If the liquid adheres to your body, immediately wash it with
soap, etc.
POINT
Never push the display with excessive force. Never push or rub it with a sharp end
of a driver, etc.
Such actions may damage the touch panel, which may affect the durability and operations.
$YRLGGLVSOD\LQJD¿[HGSDWWHUQIRUDORQJWLPHVLQFHSHUVLVWHQFHRIYLVLRQPD\
occur.
7RGLVSOD\D¿[HGSDWWHUQIRUDORQJWLPHXVH>%$&./,*+72))7,0(5@
Conformed standards
CSD-912B complies with the following standards.
EN61326: 2013 Electrical equipment for measurement, control and laboratory
use - EMC requirements.
Immunity test requirements for equipment intended for use in
industrial locations.
EN61010-1: 2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use.
EN50581: 2012 Technical documentation for the assessment of electrical and
electronic products with respect to the restriction of hazardous
substances.
JIS B 7611-2: 2015 Non-automatic weighing instruments - Metrological and
technical requirements and test - Part2: Measuring instruments
XVHGLQWUDQVDFWLRQRUFHUWL¿FDWLRQ
Caution
To comply CSD-912B with the standards, strictly observe the following conditions
of use. Otherwise, the instrument may not comply with them.
(1) Shield processing: Use shield cables except for the cable of the power cable. Refer
to the sections related to wiring for more information about the method of shield
processing.
(2) Grounding: D-class single grounding using the protective earth terminal.