Minebea CSD-912B - Page 133

113
Measurement
5
5.7. Measurement in nozzle control mode
6HWWKHQR]]OHXSRSHUDWLRQDWWKHMXGJPHQWRIVXSSOHPHQWDU\ÀRZ
1. Tap [UP AFTER COMPENSATE]
The screen to set the nozzle-up operation at the
MXGJPHQWRIVXSSOHPHQWDU\ÀRZZLOOEHGLVSOD\HG
2. Tap [VALID]/[INHIBIT].
6HWWLQJ>9$/,'@GRHVQRWSXOOWKHQR]]OHGRZQGXULQJ
MXGJPHQWRIWKHLQSXWLQVXSSOHPHQWDU\ÀRZPRGH
Default: [INHIBIT]
POINT
- Refer to "5.5. Measurement in
VXSSOHPHQWDU\ÀRZGLVFKDUJHPRGHIRU
more information about the
VXSSOHPHQWDU\ÀRZPRGH
3. Tap [OK].
The nozzle-up operation at the judgment of
VXSSOHPHQWDU\ÀRZKDVEHHQVHWDQG>23(5$7,21
2)12==/(@GHOHWHVFUHHQZLOOEHGLVSOD\HG
(2) [BATCH START DELAY TIMER] (waiting time for nozzle down) settings
6HWWKHZDLWLQJWLPHIURPWKHVWDUWRIPHDVXUHPHQWXQWLOQR]]OHGRZQ
1) Set the waiting time for nozzle-down
1. Enter the waiting time until nozzle-down.
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHZDLWLQJWLPHIURPWKHVWDUWRIPHDVXUHPHQWXQWLO
QR]]OHGRZQKDVEHHQVHWDQG>6(48(1&(
&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHZDLWLQJWLPHIRUQR]]OHGRZQ
The setting is completed if the value set by the step
1) appears under [BATCH START DELAY TIMER].