Minebea CSD-912B - Page 147

127
Measurement
5
5.8. Measurement in recipe mode
(1) [MIXING TIME OUTPUT ON] settings
Set the output time of mixing signals.
1) Set the output time of mixing signals
1. Enter the output time of mixing signals.
$OORZDEOHUDQJHWR
Default: 0
POINT
6HWWLQJPDNHVPL[WXUHXQDYDLODEOH
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
The output time of mixing signals has been set, and
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRXWSXWWLPHRIPL[LQJVLJQDOV
The setting is completed if the value set by the step
1) appears under [MIXING TIME OUTPUT ON].
(2) [MIXING FINISH OUTPUT ON] settings
6HWWKHRXWSXWWLPHRIPL[LQJ¿QLVKVLJQDOV
6HWWKHRXWSXWWLPHRIPL[LQJ¿QLVKVLJQDOV
(QWHUWKHRXWSXWWLPHRIPL[LQJ¿QLVKVLJQDOV
$OORZDEOHUDQJHWR
Default: 0.00
POINT
6HWWLQJPDNHVPL[WXUHXQDYDLODEOH
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHRXWSXWWLPHRIPL[LQJ¿QLVKVLJQDOVKDVEHHQ
VHWDQG>6(48(1&(&21752/@ZLOOEH
displayed.