Minebea CSD-912B - Page 170

150
Measurement
5
5.11. Settings related to measurement
POINT
- 1HWZHLJKWRIIVHWLVQRWH[HFXWHGLIWDUH
ZHLJKWFDQFHOODWLRQKDVDOUHDG\EHHQ
H[HFXWHG7DUHZHLJKWFDQFHOODWLRQLV
JLYHQSULRULW\RYHUQHWZHLJKWYDOXHRIIVHW
2. Tap [OK].
The operation of preset tare been set, and [BASIC
)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRSHUDWLRQRISUHVHWWDUH
The setting is completed if the item set by the step
1) appears under [OPERATION OF PRE. TARE].
(2) [PRESET TARE=0 CHOICE] settings (use of the last tare value)
6HWZKHWKHUWRXVHWKHSUHVHWWDUHYDOXHEHIRUHFKDQJHRUWRFOHDUWKHYDOXHZKHQ\RXVZLWFK
EUDQGVIURPRQHZLWK>35(6(77$5(@VHWWRDQRWKHUZLWKRXW>35(6(77$5(@ZKLOH
[OPERATION OF PRE. TARE] is set to [VALID].
1) Set the use of the last tare value
1. Select the operation of use of the last tare
value.
[THE LAST TARE IS USED]: Use the preset
WDUHYDOXHEHIRUHVZLWFKRIEUDQGV
[TARE CLEAR]: Clear the preset tare value
EHIRUHVZLWFKRIEUDQGV
Default: [TARE CLEAR].
2. Tap [OK].
Use of the last tare value been set, and [BASIC
)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHVHWWLQJVRIXVHRIWKHODVWWDUH
value.
The setting is completed if the item set by the step
2) appears under [PRESET TARE=0 CHOICE].
POINT
,I\RXWU\WRH[HFXWHWDUHZHLJKWFDQFHOODWLRQZKLOHSUHVHWWDUHLVEHLQJH[HFXWHG
WDUHZHLJKWFDQFHOODWLRQZLOOEHH[HFXWHGE\FDQFHOLQJWKHSUHVHWWDUH7DUHZHLJKW
cancellation and preset tare cannot be used at the same time.
,I\RXH[HFXWH]HURVHWZKLOHJURVVZHLJKWVDUHEHLQJGLVSOD\HGWDUHZHLJKW
FDQFHOODWLRQZLOOEHFOHDUHG,I>23(5$7,212)35(7$5(@KDVEHHQVHWWR>1(7
:(,*+72))6(723@KRZHYHUWKHQHWZHLJKWRIIVHWYDOXHZLOOQRWEHFOHDUHG