Minebea CSD-912B - Page 176

156
Measurement
5
5.11. Settings related to measurement
(1) [TARE AT POWER ON] settings
6HWZKHWKHUWRH[HFXWHWDUHZHLJKWFDQFHOODWLRQZKHQ&6'%LVWXUQHGRQ
1) Set tare weight cancellation at power-on
1. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
2. Tap [OK].
7DUHZHLJKWFDQFHOODWLRQDWSRZHURQKDVEHHQVHW
DQG>%$6,&)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHVHWWLQJVRIWDUHZHLJKW
cancellation at power-on.
The setting is completed if the item set by the step
1) appear under [TARE AT POWER ON].
(2) [TARE CLR. AT POWER ON] settings
6HWZKHWKHUWRFOHDUWKHYDOXHRIWDUHZKHQ&6'%LVWXUQHGRQ
1) Set clearing the value of tare at power-on
1. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
2. Tap [OK].
&OHDULQJWKHYDOXHRIWDUHDWSRZHURQKDVEHHQVHW
DQG>%$6,&)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHVHWWLQJVRIFOHDULQJWKHYDOXHRI
tare at power-on.
The setting is completed if the item set by the step
1) appear under [TARE CLR. AT POWER ON].