Minebea CSD-912B - Page 178

158
Measurement
5
5.11. Settings related to measurement
(1) [OPERATION OF HOLD] settings
Set the condition to hold the display of the load value, comparison results of the setting
YDOXHVRI>%5$1'&2'(@DQGZHLJKLQJYDOXHVDQGWKHGDWDRXWSXWIURPH[WHUQDOGHYLFHV
1) Set the operation condition of hold
1. Select the operation condition of hold.
[SYNC. WITH HOLD]+ROGWKHPZKHQKROG
signals are input.
[SYNC. WITH BATCH FIN. ]+ROGWKHPZKHQ
PHDVXUHPHQW¿QLVKHV
[SYNC. WITH RECIPE FIN. ]+ROGWKHPZKHQ
UHFLSH¿QLVKHV
Default: [SYNC. WITH HOLD]
2. Tap [OK].
The operation condition of hold has been set, and
>%$6,&)81&7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRSHUDWLRQFRQGLWLRQRIKROG
The setting is completed if the item set by the step
1) appears under [OPERATION OF HOLD].
(2) [LOAD DISPLAY VALUE HOLD] settings
6HWZKHWKHUWRKROGWKHORDGYDOXHGLVSOD\RI:HLJKLQJVFUHHQLIWKHRSHUDWLRQFRQGLWLRQLV
met.
1) Set holding the load value display
1. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
2. Tap [OK].
Holding the load value display has been set, and
>%$6,&)81&7,21@ZLOOEHGLVSOD\HG