Minebea CSD-912B - Page 183

163
Measurement
5
5.11. Settings related to measurement
(1) Settings of operation of automatic accumulation
6HWZKHWKHUWRDXWRPDWLFDOO\DFFXPXODWHORDGYDOXHV
1) Set the operation of automatic accumulation
1. Select the operation of automatic
accumulation.
[OFF]: Not accumulate load values.
[SYNC. WITH FINISH]: Accumulate load values
ZKHQPHDVXUHPHQW¿QLVKHV
[AUTO ACCUM. AT STABLE]: Accumulate load
YDOXHVZKHQWKH>67$%/(@ODPSOLJKWVRQ
Weighing screen.
Default: [OFF]
2. Tap [OK].
The operation of automatic accumulation has been set,
DQG>:(,*+,1*23(5$7,21@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRSHUDWLRQRIDXWRPDWLF
accumulation.
The setting is completed if the item set by the step
1) appears under [AUTOMATIC ACCUM. ].
(2) [CONDITION OF AUTO ACM. ] settings
Set the condition to automatically accumulate load values.
1) Set the condition of automatic accumulation
1. Select the condition of automatic
accumulation.
[IN OK MODE]: Accumulate load values only
ZKHQWKH>2.@ODPSOLJKWVRQ:HLJKLQJVFUHHQ
[NO CONDITION]: Accumulate load values
ZLWKRXWOLPLW
Default: [NO CONDITION]
2. Tap [OK].
The condition of automatic accumulation has been
VHWDQG>:(,*+,1*23(5$7,21@ZLOOEH
displayed.