Minebea CSD-912B - Page 270

9.6.RS-232C interface
250
External equipment
9
POINT
- To set the settings other than [TARGET OF STREAM/PRINT], follow the same
procedures described in "9.1.3 Communication setting" on the RS-232C
communication setting screen.
- Communication with the RS-232C interface is executed only during weighing
operation. The error command is returned except during weighing operation.
&6'%GRHVQRWFRQWUROWKHFRPPXQLFDWLRQÀRZ
- The CTS/RTS signal is not used.
;ÀRZFRQWUROLVQRWH[HFXWHG
- The communication operation is interactive.
(1) Stream/print output target setting
Sets data to be output in stream mode and in synchronization with the print signal.
1) Set an output target
1. Select an output target.
6HOHFWLRQV/2$'',63/$<*52661(7/2$'
',63:,7+67$7(
,QLWLDOYDOXH/2$'',63/$<
2. Tap [OK].
The output target will be set, and the RS-232C
communication setting screen 1/1 will be displayed.
The RS-232C communication setting screen will be displayed.
Tap [RS-232C].