Minebea CSD-912B - Page 88

68
Measurement
5
5.3. Measurement in simple comparative mode
7KHÀRZRIPHDVXUHPHQWLQVLPSOHFRPSDUDWLYHEDWFKPRGHLVDVIROORZV
Corresponding state display lamp lights according to judgment results.
- Fed [NET]* < setting value of [FINAL] - setting value of [UNDER]: The [UNDER] lamp
lights.
- Fed [NET]* > setting value of [FINAL] + setting value of [OVER]: The [OVER] lamp lights.
6HWWLQJYDOXHRI>),1$/@VHWWLQJYDOXHRI>81'(5@IHG>1(7@VHWWLQJYDOXHRI>),1$/@
+ settings value of [OVER]: The [OK] lamp lights.
- Fed [GROSS] or [NET]* > setting value of [FULL]: The [FULL] lamp lights.
*>1(7@7KHORDGH[FOXGLQJWKHZHLJKWRIWKHFRQWDLQHU
POINT
,I>35(/,0@RI>%5$1'&2'(@KDVEHHQVHWWRIXOOÀRZLVQRWH[HFXWHG
,I>35(/,0@RI>%5$1'&2'(@KDVEHHQVHWWRPHGLXPÀRZLVQRWH[HFXWHG
- You can change the comparative target for the value of [ZERO BAND] and
[FULL]. Refer to "5.11.2. Comparative target settings of zero band" and "5.11.3.
Comparative target settings of full" for more information.
- If start signals are not used, corresponding state display lamp lights according to
ZHLJKLQJVWDWHV
)HG>1(7@VHWWLQJYDOXHRI>),1$/@
setting value of [PRELIMINARY2]
)HG>1(7@VHWWLQJYDOXHRI>),1$/@
setting value of [PRELIMINARY1]
>*5266@RU>1(7@VHWWLQJYDOXHRI>=(52%$1'@
Measurement start
)HG>1(7@VHWWLQJYDOXHRI>),1$/@
setting value of [F-FALL]
Measurement is complete, and judgment
RIZHLJKLQJYDOXHV
The [ZERO BAND] lamp lights.
7KH>))/2:@ODPSOLJKWVDQGIXOOÀRZ
starts.
The [M. FLOW] lamp lights, and medium
ÀRZVWDUWV
The [D. FLOW] lamp lights, and dribble
ÀRZVWDUWV
The [FINISH] lamp lights.