EasyManuals Logo

Mirion Technologies MiniSentry-2 User Manual

Mirion Technologies MiniSentry-2
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
USE MANUAL
MINISENTRY-2
76 / 170
107911_D User manual MINISENTRY-2_En.docx
MIRION TECHNOLOGIES (Canberra) S.A.S, BP249, ZI de Vauzelles, 3760
2
Loches Cedex
Messages on screen Action
The “High background” alarm option is enabled
and background is upper than the “High
background trip level”.
Adjust the value
With purple portal LED blinking.
In « Enter wait » and « Walk through » modes,
release the portal to perform the background
acquisition
In « Enter wait » mode, the user leaves before
the end of measurement.
« Monitor calibration expired » setting is with
« Warning » option.
The monitor is usable but it is imperative to carry
out a calibration (§ 9.11.3).
With purple LEDs blinking
« Monitor calibration expired » setting is with
« Out of service » option.
The monitor is out of service and it is mandatory
to carry out a calibration (§ 9.11.3).
« Probe calibration expired » setting is with
« Warning » option.
The portal probes is usable but it is imperative to
carry out a calibration with Canberra Smart
Probe Software (CSPS) software (§ Erreur !
Source du renvoi introuvable.)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mirion Technologies MiniSentry-2 and is the answer not in the manual?

Mirion Technologies MiniSentry-2 Specifications

General IconGeneral
BrandMirion Technologies
ModelMiniSentry-2
CategoryMonitor
LanguageEnglish

Related product manuals