Mitsubishi 700 Series

EMBEDDED WEB SERVER
97
6
6.4.5 XTPro Supported Commands
For a summary of the supported XTPro commands, refer to Table 25. Note that two simultaneous XTPro
connections are available.
Table 25: Supported XTPro Commands
Command
Supported
Notes
noop
Yes
-
vzn
Yes
Supports XTPro specification version 1
id
Yes
-
read_data
Yes
“reference” is the inverter’s register (e.g. “2” for
frequency command), while “data_value” is a 16-bit
hexadecimal value (e.g. “1F4” for a decimal value of
500)
write_data
Yes
load_file
Yes
The absolute file path must start with a forward slash ‘/’
store_file
Yes
reinit
No
Reinitializes only the configurable drivers and services
(does not perform a complete device soft reboot)
auth
Yes
Authorization is not required
cov
Yes
COV notification messages are sent every 200ms