PROTOCOL-SPECIFIC INFORMATION
9.7.2 Read/Write Commands
Table 49 lists the supported commands. Device read/write commands only support 16-bit word access.
Table 49: MELSEC Client Commands
Type
Name
Code
Code
Points
Device Memory Batch Write
Device Memory Batch Write
9.7.3 Connection Timeout Options
In the studio’s Project panel, navigate to A7NETH-2P…Ethernet…MELSEC Client. The following
configuration options will determine the actions to be taken if the connection is abnormally terminated or
lost. While this feature provides an additional level of fail-safe functionality for those applications that
require it, there are several ramifications that must be understood prior to enabling this capability. Note
that a certain degree of caution must be exercised when using the timeout feature to avoid “nuisance”
timeouts from occurring.
Timeout Action
Select an action from the drop down menu:
“None”..................................... No effect. The inverter will continue to operate with the last available
settings.
To Next Page
Loading...
