PROTOCOL-SPECIFIC INFORMATION
Set the properties to match the configuration on
the device. The properties must be appropriate for
the application and the PROFINET network.
Set the Update Rate (ms). For this example, the
Update Rate (ms) is set to “8” ms.
Assign a unique Device Name. For this example,
the Device Name is set to “interfacecard”.
Assign a unique and compatible IP Address. For
this example the IP Address is set to
“192.168.17.102”.
The resulting properties are shown in Figure 98.
9.9.8.4 Save the Configuration
The device configuration is now complete. Save and perform any necessary compilation of the
configuration. Download the application and configuration to the PLC. The PLC application program can
then be started. Please consult with the vendor of your PROFINET PLC software for additional
programming and configuration details.
Figure 98: Set Device Properties
To Next Page
Loading...
