• If you begin changing a parameter value and then decide to abandon the change, pressing the ESC
key on your keyboard will abandon the change and redisplay the current parameter value.
• When editing a parameter value, clicking someplace off the entry cell is equivalent to hitting the
ENTER key.
6.2.4 Parameter List Filter
A filter function provides Parameter List search capabilities. To use
the filter function, simply type a word into the filter entry box and
then click the “filter” button. Refer to Figure 11. The filter will then
display only those parameters currently available in the Parameter
List that satisfy the search criteria. Once a filter has been entered, it
will continue to be applied to all information normally displayed in
the Parameter List. To remove the filter, delete all characters
contained in the filter entry box and then click the “filter” button.
6.2.5 Radix Selection
Figure 12 shows the radix selection buttons that allow changing the
Parameter List “value” column data display and entry radix between
decimal and hexadecimal formats.
When “DEC” is selected, the “value” column heading will be “Value
(Decimal)”, current parameter values will be displayed in decimal,
and values to be written to parameters must be entered in decimal format. For example, to change the
inverter’s frequency command to 40.00Hz, enter the decimal value 4000.
Figure 11: Parameter List Filter
Figure 12: Radix Selection
To Next Page
Loading...
