Mitsubishi 700 Series

REGISTER NUMBERING AND BEHAVIOR
53
4
11 are invalid in the initial status. When using bit 8 to bit 11, change the signals with Pr. 185, Pr. 186, Pr.
188, Pr. 189 (input terminal function selection).
4.4 Frequency Command Register
The frequency command (RAM) is register 2 and the frequency command (EEPROM) is register 3. The
frequency is in 0.01Hz increments. If Pr. 37 = 1 to 9998 or Pr. 144 = 2 to 10, 102 to 110, these registers
will specify the speed (in 1RPM increments.)