group, and then holding down the SHIFT key while selecting the last group in the range. When a
parameter group is selected, the parameters contained in that parameter group are displayed in the
Parameter List (refer to section 6.2.3).
6.2.3 Parameter List
The parameter list is shown in Figure 10. The parameters that are displayed in the list at any given time
depend on the parameter groups that are currently selected (refer to section 6.2.2) and the filter (refer to
section 6.2.4).
The first column of the Parameter List shows the inverter parameter (Pr. XXX) number that is normally
used when accessing a given register via the inverter’s keypad. Note that not all registers will have
parameter number entries: command and monitor registers, for example, are not accessed via the
inverter’s keypad by entering a “Pr. XXX” number, and their associated parameter column fields on the
Monitor tab are therefore empty. Also note that this column is for user convenience and inverter user’s
manual cross-reference only: parameters are not referenced through the interface card by their
parameter numbers, but by their register numbers.
The second column of the Parameter List shows the register number that provides network access to
each parameter (refer to section 4). The third column contains the parameter descriptions, which are
used by the filter function. The last column performs two functions: it displays the current value of the
parameter, and (for writable parameters) also allows changing the parameter’s value by clicking on the
number in the value column and entering the new value.
To Next Page
Loading...
