Mitsubishi 700 Series

PROTOCOL-SPECIFIC INFORMATION
163
9
Table 34: CSP (PCCC) Read/Write Services
Service Code
PLC5 Typed Read
0x68
PLC5 Typed Write
0x67
PLC5 Word Range Read
0x01
PLC5 Word Range Write
0x00
SLC Typed Read
0xA2
SLC Typed Write
0xAA
9.3.3 Inverter Register File Number Offset Format
The formula to calculate which register is targeted in the interface card is provided in Equation 3.
( ) offset+×= 10010 -number fileregistertarget
Equation 3
In Equation 3, “target register” ∈[1…1899], “file number” ∈[10…28] (which means N10…N28), and
“offset” is restricted only by the limitations of the programming software (but is a value of 1899 max).
Refer to section 4.1 for the register list. Table 35 provides some examples of various combinations of
file/section numbers and offsets/elements which can be used to access inverter registers. Note that
there are multiple different combinations of file/section numbers and offsets/elements that will result in
the same inverter register being accessed.