Mitsubishi 700 Series

INVERTER SETTINGS
34
3 INVERTER SETTINGS
The inverter parameters listed in Table 16 are critical for overall operation of the end-to-end
communication system. Some of these parameters must be set to specific values, and some may have
multiple allowable settings depending on the desired operation of the overall application. Although there
may be many other inverter parameters that will require configuration for your specific application, it is
important to understand the manner in which the following parameters will impact successful
communications with, and control of the inverter.
Table 16: Inverter Settings
Parameter
Number
Name
Refer to
Page
79
Operation mode selection
38
338
Communication operation command source
42
339
Communication speed command source
42
340
Communication startup mode selection
38
342
Communication EEPROM write selection
46
550
NET mode control source selection
42
232, 233, 234, 235
IP address
35
236, 237, 238, 239
Subnet mask
35
888, 889
Default gateway address
35