PROTOCOL-SPECIFIC INFORMATION
Register
The inverter register (refer to section 4) associated with the word offset. For the Monitor Data object,
enter a “status” register to be monitored. For the Command Data object, enter a “command” register that
can be written.
Network Number
Specifies the network number of the target station (0x0…0xEF).
Node Number
Specifies the node number of the target station (0x1…0x78, 0x7D, 0x7E, 0xFF).
Processor Number
Specifies the processor number of the target station (0x3D0…0x3D3, 0x3E0…0x3E3, 0x3FF).
9.8.6 Diagnostic Objects
Each command and monitor data object can optionally include a diagnostics object for debugging and
diagnostics. Refer to section 5.9.
Diagnostic Index
Enter the diagnostic index at which to store the diagnostics information.
To Next Page
Loading...
