Mitsubishi 700 Series

MITSUBISHI CONFIGURATION STUDIO
71
5
The network settings of a discovered card can be configured
remotely by:
• Right-clicking on the device in the Project panel and
choosing Configure Network Settings… from the context-
sensitive menu.
• Selecting the device in the Project panel and navigating to
Device…Configure Network Settings...
The network settings pop-up should appear similar to Figure 3.
Modify the network settings as necessary and click the OK
button for the changes to take effect. Note that this will cause
the device to become temporarily inaccessible and may fault the
inverter.
5.6 Manage Device Parameters
The accessibility and scan priority of the inverter parameters can be adjusted (refer to Figure 4). This is
an advanced feature and must only be used after consulting technical support to determine the
appropriate settings for the target application. The Manage Device Parameters configuration window is
found by:
• Right-clicking on the device in the Project panel and choosing Manage Parameters… from the
context-sensitive menu.
• Selecting the device in the Project panel and navigating to Device…Manage Device Parameters...
Figure 3: Remotely Configure
Network Settings