Mitsubishi 700 Series - Page 133

PROTOCOL-SPECIFIC INFORMATION
120
Table 30: Output Instances 20 and 21 Detail
Instance
Byte
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
20
0
Fault
Reset
Run
Fwd
1
2
Speed Reference (Low Byte)
3
Speed Reference (High Byte)
21
0
NetRef NetCtrl
Fault
Reset
Run
Rev
Run
Fwd
1
2
Speed Reference (Low Byte)
3
Speed Reference (High Byte)
Mapping Detail
Run Fwd: forward rotation command (0=forward rotation off, 1=forward rotation on). Maps to inverter
register 1, bit 1 (forward rotation command).
Run Rev: reverse rotation command (0=reverse rotation off, 1=reverse rotation on). Maps to inverter
register 1, bit 2 (reverse rotation command).
Fault Reset: Inverter reset command (0=no action, 0→1 rising edge=reset value 0x9966). Maps to
inverter register 5 (inverter reset).