Mitsubishi 700 Series User Manual

A-1
Thank you for choosing this inverter plug-in option for the
Mitsubishi 700 Series Inverter. This instruction manual
provides handling information and precautions for use of this
equipment. Incorrect handling may cause unexpected failures
or damage. In order to ensure optimal performance, please
read this manual carefully prior to use of the equipment.
Please forward this manual to the end user of the equipment.
This section pertains specifically to safety
issues
Do not attempt to install, operate, maintain or inspect this
product until you have read through this instruction manual and
any related documents carefully, and can use the equipment
properly. Do not use this product until you have a full working
knowledge of the equipment, safety information and
instructions. In this instruction manual, the safety instruction
levels are classified into "WARNING" and "CAUTION" levels.
Assumes that incorrect handling
may cause hazardous conditions
resulting in death or severe injury.
Assumes that incorrect handling
may cause hazardous conditions
resulting in moderate or slight
injury, or may cause physical
damage only.
Please note that even the level may lead to
serious consequence depending on conditions. Please be sure
to follow the instructions of both levels as they are critical to
personnel safety.
SAFETY INSTRUCTIONS
1. Electrical Shock Prevention
WARNING
• Do not open the front cover of the inverter while power is on
or while the inverter is running, as an electrical shock may
result.
• Do not operate the inverter with the front cover or wiring cover
removed, as accidental contact with exposed high-voltage
terminals and internal components may occur, resulting in an
electrical shock.
• If power is off, do not remove the front cover except when
necessary for wiring or periodic inspection. While the front
cover is removed, accidental contact with exposed high-
voltage terminals and internal components may occur,
resulting in an electrical shock.
• Prior to starting wiring or inspection, confirm that input power
to the inverter has been switched off via observation of the
inverter’s display panel. Additionally, wait for at least 10
minutes after removal of input power, and then confirm that all
residual voltage has been dissipated by using a voltage meter.
Internal DC bus capacitors may contain high voltages for
several minutes after removal of input power, resulting in a
dangerous situation should anything come into contact with
them.
• All personnel involved in the installation or inspection of this
equipment should be fully competent to perform the required
work.
• Always install plug-in options prior to wiring main power.
• Do not touch the plug-in option with wet hands.
• Do not subject the cables to scratches, excessive stress,
heavy loads or pinching.
WARNING
CAUTION

Mitsubishi 700 Series Specifications

General

Control Method	Vector Control
Overload Capacity	150% of rated current for 60 seconds
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit
Communication Options	RS-485, Profibus, Ethernet
Output Power Range	0.4 kW to 630 kW
Cooling Method	Forced air cooling (fan) (Varies by model)
Operating Temperature	-10 to +50°C (Varies by model, may be derated at higher temperatures)
Storage Temperature	-20 to +65°C
Humidity	95% RH or less (non-condensing)
Altitude	Up to 1000 m above sea level (Derating may be required above 1000 m)
Enclosure Rating	IP20
Model	FR-A700, FR-F700, FR-E700, FR-D700, FR-S700