MultiSmart Installation & Operation Manual
19 Datalogger
The MultiSmart comes with a sophisticated datalogger. The results can be viewed by pressing the History
button from the main screen. Also, the data can be downloaded onto a laptop and viewed via Excel, Access,
or any other reporting/database tool.
The primary datalogger – called the Event Logger - stores faults and events and is fully configurable.
There are additional datalogging options (which are explained later in this section):
• Crisis Logging
• Interval Logging
The datalogger stores approximately 50,000 events and faults. Each event or fault is date/time stamped.
By default, the following are configured to be logged:
• All faults
• Level
• Pump starts/stops
• Pump mode changes
• Changes to analog inputs and level by more than 5%
• Voltage changes of more than 10 V
• Flow values and overflow events – if the optional flow module is installed
• Profile changes
• Pump power factor
• SMS send/receive
• Level Simulation activates/deactivates
• Pump efficiency yesterday
• Energy accumulators per pump
• IRT changes
• Single or 3-phase current changes
• User logins, invalid logins, invalid administrator logins
• Unforced restarts (watchdog)
• Temperature changes of more than 10°C
MultiSmart_IO_Manual_R20 Page 163 of 260
To Next Page
