MultiSmart Installation & Operation Manual
31.2 Restore a Backup
Navigate to:
This allows an existing configuration to be loaded into the MultiSmart. There are three possibilities: restore
the previous configuration (automatically saved to internal memory), restore a (manually saved) backup
version (stored in internal memory), or restore from an SD card or USB.
Figure 178 – Restoring Saved Configurations
31.2.1 Restore from Previous Configuration
This option restores the previous automatically saved configuration. The configuration is automatically saved
every time prior to a change taking effect. To restore the previous configuration, select RTU Previous and
then press Restore. A confirmation message is then displayed.
NOTE: In the event that the current configuration becomes corrupt (displayed as an Application
Failure), the MultiSmart loads the Previous Configuration and if this also fails, the Backup configuration
is loaded.
31.2.2 Restore from Backup Configuration
This restores the last backup of the configuration that was saved by the user to internal memory. To restore
the backup configuration, select RTU Backup and then press Restore. A confirmation message is then
displayed.
31.2.3 Restore from External Memory (SD Card or USB)
A configuration can be restored from an SD card or USB. To restore a saved configuration, insert the SD
card or USB, select the desired configuration from the list and then press Restore. A confirmation message
is then displayed.
Page 230 of 260 MultiSmart_IO_Manual_R20