1
Scanning with a TWAIN driver 1-19
Basic scan functions
Scanning with a TWAIN driver
You can use a TWAIN-compliant Windows application on your computer to scan a
document.
NOTE
•Install the TWAIN scanner driver to the computer before using this function.
For details on installing the driver, see chapter 1, “Installing to Windows” in the
Printer Guide.
•To scan a document with a TWAIN driver, you should connect the machine either to
a network and setup the “TCP/IP Settings”, or directly with an USB cable.
•Since the operation procedure differs according to the application software you are
using, refer to the documentation for the application software for details.
1
Load the document.
2
Start the application software that supports TWAIN on your computer.
3
Click [Scan] and select “Muratec MFX-35x0 NW Scan”.
•This command may differ according to the application you are using.
•If you have connected the computer and the machine with a USB cable, select “Muratec
MFX-35x0 Scan”. Proceed to step 5.
4
Enter the IP address of the machine, and click [OK].
•This procedure is required only for the first time.
•If you do not know the IP address, you can detect the IP address of the connected devices
on “Device Search” screen. First, click [Search] to display the device search screen. Next,
click [Refresh]. If the “Windows Security Alert” screen is displayed, click [Unblock] or [Allow
access], and then click [Refresh] again. Select the device name from the list, and click [OK].
(The “Windows Security Alert” screen is not displayed from the second time you perform this
operation.)
•Enter the HTTP port number, if necessary.