Muratec MFX-3530 - Setting the Contrast

1
2
3
Basic faxing 3-9
Basic fax functions

Setting the contrast
You can set the contrast to scan with according to the document.
Lightest:
Lighter:
Normal:
Darker:
Darkest:
Select to scan with the lightest contrast.
Select to scan with a contrast between the normal contrast and the lightest contrast.
Select to scan with the normal contrast.
Select to scan with a contrast between the normal contrast and the darkest contrast.
Select to scan with the darkest contrast.
1
Load the document.
2
Press [Fax] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until “Fax Ready” screen is
displayed.
3
Press [Contrast].
If [Contrast] is not displayed, press [Advanced] and then [Contrast].
4
Select the desired contrast, and press [Enter].
DarkerLighter
Lightest Darkest
Normal
5
Specify the destinations, and press <Start>.
•For details on specifying the destinations, see “Specifying destinations” (page 5-2).
•If you loaded the document in the automatic document feeder, this concludes the procedure.
•If you loaded the document on the document glass, the message “Set next document.” is
displayed when the loaded documents have been scanned. Load the next document, and
press [Next Doc]. Press [Tx Start] to start transmission.