2-14 Advanced scan functions
Duplex scan
You can easily scan a two-sided document using this mode. Just load the duplex
document in the automatic document feeder, and press <Start>.
NOTE
•This setting is only available with the automatic document feeder.
•You cannot scan duplex document when both 600 dpi resolution (page 1-17) and
color scan (page 1-18) are set.
1
Press [Scan] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until “Scan Ready” screen
is displayed.
2
Press [Advanced].
3
Press [Duplex Scan].
4
Select [Long Edge] or [Short Edge], and press [Enter].
•Select [OFF] to deselect the setting.
•Refer to the display and set the document in the right direction.
5
Press [Close].
6
Specify the destinations, and press <Start>.
•For details on the procedure, see “Basic scanning” (page 1-2).
•The display shows “Set next document.” when scanning is over.
To Next Page
Loading...
Need help?
General
