Muratec MFX-3530 - Specifying Default Settings

1
2
3
4
5
6
7
Specifying default settings 7-29
Machine settings
Specifying default settings
The default values are those used when you press <Reset> to return to the ready
screen. The machine returns to the default settings if it is left without any operation
for a designated period of time. Changing the default values of often-used functions can
shorten the time required to adjust settings.
NOTE
You can set the time it takes to return to the default settings. For details, see chapter 1,
“Specifying default settings” in the Administrator’s Guide.
Specifying default scanner settings

Setting procedures
1
Press [Setting] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until My MFP menu
screen is displayed.
2
Press [Default Setting].
3
Press [Scanner Settings].
4
Press [Default Settings].
5
Select the function to set, and press [Enter].
For details, see “List of default scanner settings” (page 7-30).