Muratec MFX-3530 - Selecting Destination from the History

1
2
3
4
5
Specifying destinations 5-13
Specifying destinations
Selecting destination from the history

Using dialing history (Redial)
When transmitting a fax, you can select a destination from the history of the last 10
destinations entered using the numeric keys. You can also edit the selected history before
using it as a destination.
NOTE
Transmission using destinations registered in the address book are not displayed in
the dial history.
1
Press [Fax] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until “Fax Ready” screen is
displayed.
2
Press [Redial].
If [Redial] is not displayed, press [Advanced] and then select [Redial].
3
Select the destination you want to specify.
4
To change the fax number, edit the number, and press [Enter].
To use the displayed fax number as it is, press [Enter] without editing it.
5
When there are multiple destinations, repeat the procedures from step 2.