1
2
Advanced scan functions 2-11
Advanced scan functions
Stamp (Option)
You can stamp on a document that has been scanned using the automatic document
feeder and check it has been scanned.
NOTE
•The stamp function is optional.
•This setting is only available with the automatic document feeder.
1
Press [Scan] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until “Scan Ready” screen
is displayed.
2
Press [Advanced].
3
Select [Stamp].
4
Select [ON], and press [Enter].
Select [OFF] to deselect the setting.
5
Press [Close].
6
Specify the destinations, and press <Start>.
For details on the procedure, see “Basic scanning” (page 1-2).
To Next Page
Loading...
