1-2 Basic scanning
Basic scanning
Scanning to e-mail address
You can attach the scanned document to an e-mail for transmission.
Internet
LAN
Scan
NOTE
To scan to e-mail, you should connect the machine to a network, and setup the “TCP/
IP Settings”, SMTP settings in “E-mail Settings”, and add an e-mail address to the
machine in advance.
For details on the network setting, see chapter 2, “Specifying the network settings”
in the Administrator’s Guide, and chapter 3, “Setting the e-mail environment” in the
OfficeBridge Guide.
1
Load the document.
2
Press [Scan] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press <Mode> repeatedly until “Scan Ready” screen
is displayed.
3
Set the resolution and color, as necessary.
For details, see “Resolution” (page 1-17) and “Color” (page 1-18).
To Next Page
Loading...
Need help?
General
