5-38 Installing the Operating System with Express Setup
Installing SCSI Controller Driver
If you use SCSI controller driver (Adaptec 29320), install it according to the following procedure:
1. Start [Device Manager] from [Start] menu → [Control Panel]→[Administrative Tools] → [Computer
Management].
2. Double click the SCSI Controller driver which Device Manager lists as unknown device.
3. Click [Update Driver].
4. When the "Update Device Driver Wizard" appears, select "Install from a list or specific location [Advanced]"
and click [Next].
5. Select "Don't search. I will choose the driver to install" and click [Next].
6. Click [Have Disk..].
7. Insert "Windows 2000 OEM-DISK for EXPRESSBUILDER" into the floppy disk drive, enter "a:\" into "copy
manufacturer's file from:" and click [OK].
8. Specify the following driver and click [Next].
[Adaptec SCSI Card 29320ALP - Ultra320 SCSI](When the Adaptec 29320 board is installed.)
The installation of the driver is completed.
Restart the system according to the message appeared on the screen.
To Next Page
Loading...
