Installing the Operating System with Express Setup 5-37
Optional Network Board Driver
If you want to use optional Network Boards, install the driver stored in EXPRESSBUILDER CD-ROM.
Refer to the re-installation procedure described in Appendix E.
Network Driver for optional network boards
[CD-ROM Drive Letter>:\WINNT\W2K\NS1\PRO1000\WS03XP2K]
Graphics Accelerator Driver
Standard graphics accelerator drivers that are mounted will be installed automatically. The following is the procedure
when it is necessary to install manually.
If you want to use optional Graphics Accelerator Driver board, follow the document attached to the board to install the
driver.
1. Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive.
2. Click Start menu, point to [Programs], [Accessories] and click [Windows Explorer].
3. Run "SETUP.EXE" in the following directory.
<CD-ROM Drive Letter>:\WINNT\VIDEO\SETUP.EXE.
4. Follow the message to continue the installation.
If the dialog message "Digital Signature could not been found." appears, select [Yes] to continue.
5. Remove the EXPRESSBUILDER CD-ROM from the CD-ROM drive, follow the direction on the screen and
restart the system.
USB 2.0 Driver
USB 2.0 Driver is pre-installed.
When restoring the system or re-installing the system, the driver is automatically installed in the process of updating the
system.
To Next Page
Loading...
