9-14 Upgrading Your Server
10. Provide the cable connections.
See Chapter 10 for cable connections.
NOTES:
If caps are put on the SCSI interface and/or power cables, remove them. (Save the
removed caps carefully.) Put the mating caps on the unused power connectors and
bundle the cables with a repeat tie.
Locate the termination resistor at the end of the SCSI cable of the SCSI hard disk drive
so that it may not be an obstacle.
SCSI cable
Terminator
11. Assemble the server.
12. Run BIOS SETUP utility and check to see that the hard disk drive is correctly recognized. See Chapter 4 for
details.
To Next Page
Loading...
