Configuring Your Server 4-27
IMPORTANT: This option sets [SATA RAID Enabled] in the [Advanced] - [I/O Device
Configuration] menu to [Disabled]. If the SATA hard disk drives are installed in your
server and the onboard SATA RAID feature is used, change the parameter of the [SATA
RAID Enabled] from [Disabled] to [Enabled] before exiting BIOS Setup. Leaving this
parameter as the factory-set value (Disabled) may destroy the data in hard disk drive.
NOTE: To display the [SATA RAID Enabled] menu, select [Advanced] - [I/O Device
Configuration] - [SATA Controller Mode Option] - [Enhanced].
Discard Changes
Select this item to return the values modified currently to the previous values before saving the values to CMOS.
Save Changes
Select this item to save the newly selected information to CMOS (non-volatile memory) without the termination of
SETUP.
To Next Page
Loading...
Need help?
General
