: Default
Y SETTING DATA
No. MEANING DATA MEANING
00 Do Not Disturb-System 0
1
To provide
Not provided
01 Room Cutoff-System 0
1
To provide
Not provided
02 Off-Hook Alarm 0
1
To provide See CM51 Y=12
Not provided
03 Message Waiting/Stored Call Record 0
1
To provide (for the station with MW lamp)
Not provided
NOTE: Set the second data to default when Standard SIP station is used, because Standard SIP station is un-
supported to control these features.
04 Howler tone automatic sending 0
1
Not provided See CM08>153
To provide
05 SMDR for incoming call 0
1
To provide See CM08>820, CM35 Y=049
Not provided
06 SMDR/Centralized Billing-CCIS for out-
going call
0
1
Not provided See CM35 Y=014
To provide
07 Analog data station (FAX, MODEM,
etc.) or ordinary station
See PRECAUTION (2)
0
1
Data station
Ordinary station
08 Send or not ringing signal to the single
line telephone on multiline of Multiline
Terminal
0
1
Not sent ringing signal See CM12 Y=05
Send ringing signal
09 Intra-office connection PAD 0
1
Without PAD
As per CM42>190
Analog SLT connection PAD
[For EU]
0
1
Without PAD
As per CM42>190
10 Ordinary station or VMS station 0
1
VMS station
See CM41 Y=0>44, 48, 49, CM50 Y=00
Ordinary station
Continued on next page
To Next Page
Loading...
