Page | 272
A.1.9 CONNECT AN EXTERNAL HARD DRIVE?
Connect a suitable USB cable from the external hard drive to one of TriCaster’s USB ports. Note that the hard
drive should probably be formatted using the NTSF file system (the FAT file system chokes on exported files
exceeding 4 Gigabytes, as will often be the case).
A.1.10 EJECT A HARD DRIVE?
10. Launch TriCaster, and click the Open icon on the Home Page of the Startup Screen.
11. Click the Eject gadget at upper right on the screen, and select the hard drive you wish to safely
disconnect, or…
12. Open the Live Desktop’s TriCaster Options menu by clicking the label NewTek TriCaster at left in the
Dashboard, select Eject and select the desired drive (see Section 7.1).
A.1.11 CONNECT TALLY LIGHTS?
External tally light devices and their connections vary widely. Please refer to Section 3.8 for details on
TriCaster’s tally light jack implementation.
A.1.12 CONNECT TO A NETWORK?
Please refer to Section 3.15.
A.1.13 ENABLE TERMINATION FOR VIDEO INPUTS?
TriCaster has full-time video termination. If you need to loop through (or t-off from) other video devices
(such as an external monitor) prior to TriCaster in your video pipeline, you should ensure termination is OFF
for earlier devices.
A.1.14 CONFIGURE WIRECAST® TO RECEIVE TRICASTER’S NETWORK OUTPUT?
To set up Telestream’s Wirecast
®
software to recognize TriCaster’s
Network output as a source, follow these steps:
1. Double-click the main Program monitor to open TriCaster’s
Output Configuration panel.
2. Select the desired audio and video sources for Network output,
and enable it.
To Next Page
Loading...
Need help?
General