NSK EDD Megatorque Motor - Power on

8. More Advanced Function
— 8-56 —
8.9.2.1. Power on
 If a terminal (such as NSK Handy Terminal FHT31) is connected to the CN1 connector and the Driver
Unit power is turned on, the message shown below appears on the terminal screen. The contents (the
number of characters) of this message may differ with the setting condition of the Driver Unit and System
versions.
 When the initialization of the Driver Unit completes, a prompt (colon [:]) appears and the System waits for
an entry of command.
NSK MEGATORQUE
XSY*****.*,XOP*
DD1DA0_0000.0
:_
The part indicated by * depends on the
system.
！
Caution : Be sure to turn off the power for the Driver Unit when connecting and
disconnecting the communication cable. (Otherwise it may result in failure
of the Driver Unit.