NSK EDD Megatorque Motor - Establishing Communication; Setting Parameters

4. RS-232C Communication and USB Communication
— 4-10 —
4.2.2. Establishing Communication
 First, start the EDD MEGATERM and establish communication to open the terminal screen.
1) Connect the USB cable to CN0 of the Driver Unit.
2) Press the Connect button on the EDD MEGATERM screen and check that the
communication has been established as the Connect button turns green.
3) Select the Terminal tab and open the terminal screen.
4.2.3. Setting Parameters
 Following example describes how to check, and change the current setting of parameter MV (Motor
velocity).
1) Check the current setting of parameter MV.
Enter as ? + Parameter code as follows.