NSK EDD Megatorque Motor - CN5: Connector for Power Supply; CN5 Pin-Out; CN5 Wiring Diagram

2. Specifications
— 2-40 —
2.13. CN5: Connector for Power Supply
 The connectors for CN5 are shown in the Table 2-30: Connector list
Table 2-30: Connector list
Connector of Driver Unit
PHOENIX CONTACT
MSTBA2,5/5-G-5,08-LR or equivalent
Mating connector
PHOENIX CONTACT
FKC 2,5/5-ST-5,08-LR or equivalent
2.13.1. CN5 Pin-Out
Fig 2-45: Pin-out
L
N
L
N
Control power
5
4
3
2
1
Main power
2.13.2. CN5 Wiring Diagram
Fig 2-46: Wiring diagram
MAIN
100-240VAC
CTRL
100-240VAC
L
N
L
N
CN5
Control power
Single phase
Main power
Single phase
Danger : Do not connect or disconnect the connector when the cable is energized.
Danger : A high voltage is applied to the connector after the power is turned on.
Take extra care for short circuit.
Danger : Check the orientation of the connector when inserting it. Though the
connector is lock type, be sure to insert it to the bottom. Otherwise you
cannot secure the connector.
Danger : A high voltage remains even after the main power is turned off. Be
careful not to get an electric shock.
Danger : Operate the lever on both sides slowly when disconnecting the
connector.
！
！
！
！
！