NSK EDD Megatorque Motor - Input of the Password

4. RS-232C Communication and USB Communication
— 4-11 —
2) Set the parameter MV to 0.5 [s
-1
]
Enter as Parameter code + data.
This completes the setting when the colon (:) appears on the screen.
Caution : Confirm that the colon (:) is on the screen when turning off the power of
the Driver Unit after the setting of parameters.
 Otherwise the alarm E2 “ROM error” may occur when the power is on next time.
4.2.3.1. Input of the Password
 Several parameters and commands require an entry of the password for setting and execution.
1) Enter the Password (/NSK ON)
The acknowledgment appears on the screen, and the colon appears indicating the normal stand-
by state for command entry. Then set a parameter or a command.
 However, the password is effective for only one entry of a parameter or a command.
！