NSK EDD Megatorque Motor - RS-232 C Communication with Handy Terminal

4. RS-232C Communication and USB Communication
— 4-2 —
4.1. RS-232C Communication (Handy Terminal Communication)
 Function of Handy Terminal
 Monitoring the Motor conditions, internal channel programming and setting parameters with the RS-232C
communication interface can be done easily by connecting the FHT31 Handy Terminal to connector CN1
of the Driver Unit Model EDD. (No setting such as baud rate is required.)
Caution : When connecting or disconnecting the communication cable (CN1), be
sure that the power of the Driver Unit is turned off.
 Appearance and function of each part
Fig 4-1: Handy Terminal M-FHT31
Cable
(Cable length: )
Numeric keys
Code keys (superscript)
Alphabet keys
Special code keys
SHIFT
: Shift key
Note 1)
CTRL
: Control key (Not used)
SP
: Space key
Note 2)
BS
: Back space key
Note 3)
ENT
: Enter key
Note 4)
Frame
LCD
Note: 1) SHIFT: Press a numeric key while pressing the SHIFT key to enter a code
key. A superscript of the numeric keys will be entered.
2) SP: Use this key to input a blank between letters.
3) BS: Press the BS key when correcting logged in mistakes.
4) ENT: Press the key at the end of a command or the parameter setting.
Connect
or
ESC
: Escape key (Not used)
！