NSK EDD Megatorque Motor - Adjusting; Output to Analog Monitor

9. Details of Command and Parameter
— 9-7 —
9.2.9. Adjusting
 When setting the option code “/AR” to a parameter code, you may increase or decrease a value of
parameter by the keys + / -
 The keys . and = change an increment or decrement of an input of the keys.
:VG/AJ
STEP 0.10
VG 6.00 _
 Input of R key will reset to the shipping set.
Table 9-7: Keys to be used for adjustment
Key
Description
+
A press of the key increases a value as indicated.
-
A press of the key decreases a value as indicated.
.
A press of the key changes an increment or decrement the
step to 1/10 of current setting.
=
A press of the key changes an increment or decrement of the
step to 10 times of current setting.
R
A press of the key resets the value to the shipping set.
BS
A press of the key reset the value before adjustment and
terminates adjust mode.
ENT
A press of the key sets the value as adjusted and terminates
adjusting mode.
9.2.10. Output to Analog Monitor
 The readout will be outputted to the primary analog monitor when the option code “/MN” is attached to
the parameter. In such a case, the default monitor offset or default range is specified.
 Parameter MNY (Primary analog monitor offset) changes the offset.
 Parameter MNR (Primary analog monitor range) changes the monitor range.
:LO/MN
MNR4000.000;_
 The readout will be outputted to the secondary analog monitor when the option code “/MX” is attached to
the parameter. In such a case, the default monitor offset of default range is specified.
 Parameter MXY (Secondary monitor offset) changes the offset.
 Parameter MXR (Secondary analog monitor range) changes the monitor range.