NSK EDD Megatorque Motor - Wildcard Search; Repeating Readout

9. Details of Command and Parameter
— 9-5 —
9.2.5. Wildcard Search
 When a letter of alphabet is specified following the “?”, all corresponding commands and parameters will
be displayed.
 When only the “?” is inputted, all commands and parameters will be displayed.
 The prompt “;” is on the end of each line when reading out multiple commands or parameters.
In such a case, press the SP key to scroll to the next menu or terminate the readout by the BS
key
:?P
PG0.12;
PGL0.05;
PC0;
PS1;
PK0;
PWU0;
PWV0;
PWW0;
PF50.00
:
 In the display in the terminal screen of EDD MegaTerm, all corresponding parameters and commands are
displayed in a screen.
9.2.6. Repeating Readout
 When an option code “/RP” is added to a readout command such as the command TP, the System repeats
to display the readout.
 A press of the BS key terminates repetitive readout.
:?SG/RP
SG 6 _
 Adjust the parameter MR (Monitor refresh rate) when the settings of parameters are hard to read because
of their frequent changes. The readout stays on the display for a time set by the parameter MR for easy
confirmation of readout.