NSK EDD Megatorque Motor - Reset to Shipping Set; Readout of Parameter

4. RS-232C Communication and USB Communication
— 4-12 —
4.2.3.2. Reset to Shipping Set
 You may reset a parameter, which has been altered once, to the shipping set. Though the command of
initialization resets all parameters to the shipping set at once, this section describes the way to rest
parameters to the shipping set one by one.
 The following example describes how to reset the parameter MV (Motor velocity) to the shipping set.
1) Enter as Parameter code + /RS.
4.2.4. Readout of Parameter
 The following example describes how to read out the parameter VG (Velocity gain).
1) Check the current setting of the parameter VG.
Enter as ? + Parameter code.
If all parameters including "VG" are read ahead of the parameter name, you will return to the
prompt “:”.