Appendix
— A-19 —
Writing the encoded file to Driver Unit Model EDD
(1) Start up EDD MegaTerm and click “ ”.
(2) Select “Open” in the menu bar. Click “ ” in the dialog box and click “ ”.
Confirm that the checkbox of “Ignore version of firmware and information of XSY” and “Area to
write” are already ticked.
Fig A-16: Specifying the file to open (Selecting “Confirming message for writing”)
Tick “Send AO command.” when sending the Home offset value of Motor.
The Confirmation message for writing dialog box will be displayed. Click “ ” to end.
Fig A-17: Confirmation message for writing
This process will be completed when Writing completion dialog box is displayed. Click “ ” to end.
Fig A-18: Confirmation message for writing
Writing has been completed.
Confirm the data by using parameter edition or program edition screen of MegaTerm.
To Next Page
Loading...
